I was asked recently ‘Do we have PowerCLI downloaded?’. Yes, we may, but it could be anywhere and it is likely an outdated version.
There is no need to download the installer! You can install PowerCLI using the Install-Module cmdlet in Windows PowerShell. (Providing you have an internet connection!) Below we will look at the steps required to install the latest version of PowerCLI on your system.
From an elevated PowerShell prompt run the following –
If you don’t already have it installed, you will be prompted to install the NuGet Provider. Type ‘y’ and enter to continue.
You will get a further prompt to confirm you are happy to install a module from the ‘PSGallery’. Again, ‘y’ and enter to continue.
The PowerCLI Module will then begin to install. It will cycle through installing multiple dependent packages which will take a few minutes. Sit back and wait…
Once returned to the prompt, you can confirm the installation by running –
Get-Module VMware.PowerCLI -List Available | FL
You have now installed PowerCLI version 184.108.40.20647286. You will likely end up installing a later version.
Last step, load the module for use –
You’re ready to go! But…
Not every system you need to use this module on will have internet access. In this, case the ‘Save-Module’ cmdlet is your friend.
Save-Module -Name VMware.PowerCLI -Path <Path to directory>
The module will then proceed to be downloaded into the directory you have specified and will look like this –
On your target server, you will need to confirm your module paths. You can do this by using the following command. You may have more than one path.
Now copy the directory that contains the module you have saved, to a module path on the target server. Likely ‘C:\Programfiles\WindowsPowerShell\Modules’ on a Windows System.
Now the Module is on your system, all that’s left is to import the module as above –
Thanks for reading! Hope this has been of use and catch you in the next post.